[Feb-2026] Verified AVIXA Exam Dumps with CTS-I Exam Study Guide [Q173-Q196]

Q173. For an ethernet cable (UTP) to meet certification standards, the maximum length is

Q174. Bandwidth ____ as the resolution of an image increases.

Q175. Place a cable label on ____ of every cable.

Q176. Before decommissioning a system where existing components will be reused, the AV technician should:

Q177. An architectural drawing was created using the SI scale of 1:200. You measure a distance of 13 millimeters on the drawing. What is the actual distance in millimeters?
Response:

Q178. What are possible reasons for no picture on the screen?
Select all that apply.
Response:

Q179. _____ is the distance in meters between two corresponding points of two consecutive cycles.

Q180. When preparing to install a ceiling mount, what should you determine before you can determine the projector position?

Q181. SDI signals are usually transported using _____ connectors.

Q182. When pulling a group of cables through conduit, it is advisable to:

Q183. Why is it a good idea for the AV installer to provide end user training on a new system?

Q184. After performing a Technical Site Survey, all information recorded should be relayed to:
Response:

Q185. The ____ prevents an electric front projection screen from rising too much.

Q186. If you go up one octave from 250 Hz, you arrive at _____.

Q187. If a display has 800 pixels horizontally and 600 pixels vertically, what is its native resolution?

Q188. At the end of the project, once installation and verification are complete, acceptance of the completed system is documented in a commissioning report and typically signed by:

Q189. What Viewing Category applies to a space used for word processing and spreadsheets?

Q190. For what reasons is it important to set system gain? (Choose all that apply.)

Q191. Why do wall-mounted racks with swing-out glass doors require special attention during installation? (Choose all that apply.)

Q192. What assumptions should you make about an audio system when there is no audio output?
(Choose all that apply.)
Response:

Q193. In an electrical power distribution installation, the safety earth/ground connects to___.
(Choose all that apply.)
Response:

Q194. If the audio digital signal processor you have to install is discontinued by the manufacturer, what should you do?
(Select all that apply.)
Response:

Q195. What assumptions should you make about an audio system when there is no audio output? (Choose all that apply.)

Q196. When training a customer on the operation of a touch-panel interface, an example that the GUI is a good design that meets the customer’s needs is: