[Mar-2022] Valid Way To Pass Juniper Exam Dumps with JN0-663 Exam Study Guide [Q30-Q53]

NO.30 Exhibit.

Referring to the exhibit, which command would reduce the size of the OSPF database and corresponding routes?
A)

B)

C)

D)

NO.31 Exhibit:

Referring to the exhibit, a Layer 3 VPN is configured, however, the routes are being hidden.
What is the problem?

NO.32

All networks shown in the exhibit contain more than one BGP speaker. You operate ISP A and must ensure that Customer Y sends their traffic to you over the directly connected link. Customer Y is not to be used for transit into your network.
What would you do to accomplish this task?

NO.33 Exhibit:

Referring to the exhibit, you need to implement VPLS between CE-A1 and CE-A2 You must ensure that no loops are created due to the multihoming of the connection from CE-A2 to PE2 and PE3.
Based on the type of VPLS, which two solutions will satisfy this requirement? (Choose two.)

NO.34 Exhibit:

Referring to the exhibit, which two statements about route reflectors are correct? (Choose two.)

NO.35 Exhibit:

R1 assigns incoming voice traffic to the ef forwarding class. All other traffic is assigned to the best-effort forwarding class You have configured a CoS re-write rule on R1 to include the correct CoS bit values in packets sent towards R2 You want R2 to classify traffic using the CoS markings created by R1.
Which two configuration steps are necessary to accomplish this task? (Choose two.)

NO.36 Exhibit:

Your network is connected to two different ISPs and you notice that they are using your network for transit traffic.
In this scenario, which two configuration statements will solve this problem? (Choose two.)

NO.37 Exhibit:

R2 is receiving the same route from R1 and R3. You must ensure that you can load balance traffic for that route.
Referring to the exhibit, which two configuration changes will allow load balancing? (Choose two.)

NO.38 Exhibit:

Referring to the exhibit, the local BGP router is receiving IPv4 routes from the BGP neighbor, but it is not receiving L3 VPN routes from the BGP neighbor.
Which two actions should you take to solve this problem? (Choose two.)

NO.39 Exhibit:

You are receiving the same 200.0.0.0/24 BGP route from four different ISPs.
Referring to the exhibit, which ISP’s route would be selected as active?

NO.40 Exhibit:

Referring to the exhibit, which two statements are true? (Choose two.)

NO.41 Exhibit:



R4 is directly connected to both RPs (R2 and R3). R4 is currently sending all joins upstream to R3 but you want to load balance the joins between both RPs Referring to the exhibit, which configuration change will solve this issue?

NO.42 Exhibit:

You must configure an OSPF virtual link to facilitate communication between Area 0 and Area 20.
Referring to the exhibit, which two addresses should you use as the neighbor IDs of the virtual link endpoints?
(Choose two.)

NO.43 You are deploying a new EVPN service for your customers.
You must build the service based on the following requirements:
– both Layer 2 and Layer 3 functionality must be supported;
– your customers must be able to support multiple VLANs in the same EVPN instance (EVI).
In this scenario, which two types of routing instances should be configured? (Choose two.)

NO.44 Exhibit:

Referring to the exhibit, what will the IS-IS cost be for R1 to reach R3?

NO.45 Exhibit:

The exhibit shows a BGP peering session for two PE routers. The BGP session is up, but the hosts in the Layer
2 VPN that uses the BGP session are unable to communicate.
What is the problem in this situation?

NO.46 Exhibit:

You notice an inconsistency between the routing table and the OSPF database, as shown in the exhibit.
What are two reasons for this behavior? (Choose two.)

NO.47 Which two statements about wide and narrow metrics used in IS-IS are correct? (Choose two.)

NO.48 You want to allow the load balancing of traffic for an EBGP route from two different peers in the same AS.
Which three actions are needed to accomplish this task? (Choose three.)

NO.49 Exhibit:

Referring to the exhibit, which two statements are true? (Choose two.)

NO.50 Exhibit:

Referring to the exhibit, external routes are being received at R1. These routes must appear on R5.
Which action will produce this result?

NO.51 Exhibit.

R2 is receiving a route from an EBGP neighbor and is advertising the route to R4 Referring to the exhibit, which configuration on R2 will solve the issue with the route on R4?

NO.52

Referring to the exhibit, the local BGP router is receiving IPv4 routes from the BGP neighbor, but it is not receiving L3 VPN routes from the BGP neighbor.
Which two actions should you take to solve this problem? (Choose two.)

NO.53 You are responsible for configuring CoS for your network Your network includes a video application with strict latency requirements, so that any packets delayed by more than 75 ms are effectively useless. You want to ensure that you do not waste buffer space.
When configuring the scheduler for this application, which feature would you use?