Pass Your Network Appliance NS0-176 Exam with Correct 141 Questions and Answers [Q62-Q79]

Rate this post

Pass Your Network Appliance NS0-176 Exam with Correct 141 Questions and Answers

Latest [Apr 18, 2022] 2022 Realistic Verified NS0-176 Dumps

NetApp NS0-176 Exam Topics:

Section	Objectives
Information Gathering for FlexPod Solutions	– Describe the main FlexPod components
FlexPod Administration	– Demonstrate knowledge of how to administer FlexPod solutions according to FlexPod best practices – Describe FlexPod management applications – Demonstrate knowledge of how to install and upgrade the FlexPod solution
FlexPod Configuration	– Describe how to install and configure the FlexPod components – Describe how to configure neworks in a UCS solution – Describe how to configure SAN boot in a FlexPod solution – Describe knowledge of how to configure a service profile – Demonstrate knowledge of how to configure storage in a FlexPod solution – Demonstrate knowledge of how to configure Cisco Nexus switches
FlexPod Design	– Describe the storage components supported in FlexPod – Describe the networking components supported in FlexPod – Describe the compute components supported in FlexPod

NEW QUESTION 62
Which feature allows Cisco Nexus 7000 Series switches to be virtualized at the device level?

PONG

VLAN

VRF

VDC

NEW QUESTION 63
Which two technologies must be deployed for a Cisco Nexus 9000 ACI design? (Choose two.)

spine switch

VSM

APIC

LACP

NEW QUESTION 64
Exhibit:

You have FCoE configured between your Nexus 5672UP switches and UCS Fabric Interconnects running in FC end-host mode. You are experiencing disk I/O errors on your VMware FCoE datastore, but the NFS data stores on the same NetApp storage system are not exp eriencing any problems.
Referring to the Nexus output shown in the exhibit, what would cause this problem?

Port flow-control is currently off.

The no-drop QoS classes on the Fabric Interconnects are different than those on the Nexus switches.

The FCoE uplinks from the Fabric Interconnects must use the ports on the far right side of the Nexus switches.

“VL bmap” is hard to set to “off”.

NEW QUESTION 65
Which four items are required in order to create a Gold Master Boot LUN to automate the provisioning of Hyper-V hosts using the built-in LUN cloning capabilities of NetApp storage? (Choose four.)

Create additional virtual fibre channel (vfc) interfaces for the Nexus 5500

Creation of a LUN for the Gold Master Boot LUN

Configuration of the Server OS and hotfix installation

Create a new interface group on the NetApp Cluster

SysPrep of the server operating system

Creation of a service profile and zoning for Gold Master Boot LUN

NEW QUESTION 66
Which FlexPod management tool allows you to manage Storage Virtual Machines (SVMs) and replication relationships?

OnCommand Performance Manager

OnCommand Balance

OnCommand System Manager

OnCommand Insight

NEW QUESTION 67
Which two are correct about VSAN configuration within UCS Manager? (Choose two)

VSAN ID and FCoE VLAN ID have to match.

VSAN can be configured as fabric interconnect specific.

We can delete VSAN 1.

VSAN IDs 3840-4079 are not available regardless of the Fabric Interconnect mode.

VSAN can be configured as a global parameter.

In addition to SAN tab, VSANs can be configured under UCSM Server tab as well.

NEW QUESTION 68
Exhibit:

Referring to the exhibit, which two diagrams show the correct way to cable a new NetApp clustered Data ONTAP cluster with two nodes? (Choose two.)

III

NEW QUESTION 69
Which LIF role is used for SnapMirror traffic on a system running clustered Data ONTAP?

intercluster

node-management

interconnect

cluster-management

NEW QUESTION 70
Refer to the exhibit.

Which is correct for configuring FCoE?

vlan 33fcoe vsan 43int po11switchport trunk allowed vlan add 33int vfc11bind interface po11switchport trunk allowed vsan 43vsan databasevsan 43 interface vfc11

vlan 33fcoe vsan 43int po21switchport trunk allowed vsan add 43int vfc11bind interface po21vsan databasevsan 43 interface vfc 11

fcoe vsan 43int po11switchport trunk allowed vsan add 43vsan databasevsan 43

fcoe vlan 33int po11switchport trunk allowed vlan add 33vsan databasevsan 33

fcoe vsan 43int po21switchport trunk allowed vsan add 43vsan databasevsan 43

NEW QUESTION 71
Which two are true about Fabric Interconnect L1 and L2 ports in cluster mode? (Choose two)

Fabric Interconnects connected via L1/L2 have to be the same model except during the upgrade

Ports are primarily used for management traffic, but can be used for data traffic as well

Fabric Interconnect ports L1 and L2 are 10 Gb links

Ports can only run as a port channel

Ports can only run as individual links

Ports can run as a port channel or as individual links

NEW QUESTION 72
Which two are two possible features of the ‘Call Home’ feature in UCS Manager?

Generates a text message to configured cell phone numbers

Generates a syslog event

Ability to proactively open a case with the Cisco TAC with the ‘Smart Call Home’ feature

Generates emails to predefined email addresses when a problem is detected

Allows UCS to proactively pull down new software updates from Cisco

NEW QUESTION 73
You want to verify that you have configured Multipath HA correctly for all of the attached disk shelves on a NetApp cluster.
Which two commands would you execute from the cluster CLI prompt to accomplish this task? (Choose two.)

sysconfig -a

node run -node * -command disk show

node run -node * storage show disk -p

node run -node * sysconfig -a

NEW QUESTION 74
Which two operating modes are available with the Nexus 9000 Series switches? (Choose two.)

Cisco NX-OS

Cisco ACI

Cisco IOS

Cisco IOS EX

NEW QUESTION 75
VMware ESXi 6 supports which three storage protocols? (Choose three.)

iSCSI

FCP

NFS

CIFS

SMB

NEW QUESTION 76
Which two database types are supported with the VMWare vCenter 6.0 Server Appliance? (Choose two.)

Oracle

vPostgres (embedded)

Microsoft SQL Server Express

Microsoft SQL Server Enterprise

NEW QUESTION 77
Which of the following tools is designed to inventory existing VMware vSphere, Linux, and Microsoft Windows Server versions in a customer environment?

Cisco UCS Sizer for Enterprise Applications

Cisco UCS Central

Microsoft Assessment and Planning (MAP) Toolkit

Cisco Resource Comparison Tool

NEW QUESTION 78
There are 2 chassis tied to a pair of Fabric Interconnects.
First chassis, chassis-1, has 1 link between single IOM and Fabric Module. Second chassis, chassis-4, has 4 links between single IOM and Fabric Module. Chassis discovery policy is set for 2 links.
Which statement is true?

Both chassis will be added to UCS Domain utilizing all links. No additional steps needed.

Both chassis will be added to UCS Domain utilizing all links only after performing chassis acknowledgment.

Chassis-1 will not be added to UCS Domain. Chassis-4 will be added to UCS domain with all 4 links operating and no additional steps needed.

Chassis-1 will not be added to UCS Domain. Chassis-4 will be added to UCS domain with all 4 links operating after chassis acknowledgement.

NEW QUESTION 79
Which set of commands maps VLAN 100 to VSAN 100?

Nexus 5000-A#configure terminal Nexus 5000-A (config) # vlan 100 Nexus 5000- A (config-vlan_ #fcoe vsan 100

Nexus 5000-B# configure terminal Nexus 5000-B (config) # vsan database Nexus 5000-B (config-vsan)# vsan 100 Nexus 5000-B(config- vsan) #vsan 100 name FCoE-VLAN 100

Nexus 5000-A#configure terminal Nexus 5000-B (config) # vsan database Nexus 5000-A (config)# vsan 100 Nexus 5000-A (config-vsan) # fcoe vsan 100

Nexus 5000-B# configure terminal Nexus 5000-B(config-vsan) # vlan 100 Nexus 5000-B (config-vsan)# vsan 100 name vsan100

Loading …

Get 2022 Updated Free Network Appliance NS0-176 Exam Questions and Answer: https://www.dumpstests.com/NS0-176-latest-test-dumps.html

Pass Your Network Appliance NS0-176 Exam with Correct 141 Questions and Answers [Q62-Q79]

NetApp NS0-176 Exam Topics:

No Responses

Leave a Reply Cancel reply

Related Certifications

NS0-176 Practice Tests

Recent Posts

Recent Comments

Categories