[2022] Free H35-560 Exam Dumps to Pass Exam Easily [Q17-Q38]

NEW QUESTION 17
Before coverage analysis, it is necessary to obtain basic data such as the planning plan, site distribution, base station configuration, antenna feeder configuration, RS power and service load characteristics of the optimized target are a. Then obtain the information of the existing network data, conduct a comparative analysis, and find out the areas where the coverage problem may exist.

NEW QUESTION 18
In an LTE network, an interface can be configured between eNODEB and MME. Which of the following is the interface name?

NEW QUESTION 19
In the process of LTE network optimization, which of the following data sources are used for problem location analysis? (multiple choice)

NEW QUESTION 20
Which of the following carrier bandwidths does LTE support? (multiple choice)

NEW QUESTION 21
Which physical channel in LTE is used to carry paging messages?

NEW QUESTION 22
Regarding the over-zone, overlapping coverage control, which of the following statements is wrong?

NEW QUESTION 23
RSRP reference signal received power refers to the average signal power received by all REs of a Symbo bearer Reference Signa within the measured frequency bandwidth.

NEW QUESTION 24
The drive test scenario judges the success of the handover, usually based on the signaling. On the terminal side, which of the following signaling starts the handover process?

NEW QUESTION 25
The intermodulation interference of the system is usually mainly caused by second-order and third-order intermodulation, and the frequency of the second-order intermodulation product is F=2f1±f2 or 2f2±f1.

NEW QUESTION 26
Which of the following factors affect the theoretical peak of LTE cells? (multiple choice)

NEW QUESTION 27
Which of the following is not included in the survey station preparation information?

NEW QUESTION 28
The insertion loss of the cavity power divider is larger than that of the microstrip power divider.

NEW QUESTION 29
The reason values for LTE RRC establishment include: emergency calk h ig h Priority Access x mt-Access mo-Singnalling and mo-Data.

NEW QUESTION 30
What are the evaluation methods for overlapping coverage issues? (Multiple choice)

NEW QUESTION 31
Which of the following statements about LTE tools is correct? (Multiple Choice)

NEW QUESTION 32
Which of the following is not a weak coverage solution?

NEW QUESTION 33
The single-station verification test only needs to verify whether the cell status in the idle mode is normal.

NEW QUESTION 34
Which of the following types of warm wires are commonly used? (multiple choices)

NEW QUESTION 35
Regarding indoor distribution antennas and components, which of the following statement is wrong?

NEW QUESTION 36
Which of the following reference signals are available in both LTE TDD and FDD LTE systems? (Multiple choice)

NEW QUESTION 37
LTE can obtain various interface signaling through LMT, M2000, and drive test tools.

NEW QUESTION 38
The LTE system can only switch based on frequency priority.