NACE-CIP2-001 Actual Questions – Instant Download 100 Questions [Q54-Q75]

NEW QUESTION 54
Coating Surveys are legally required:

NEW QUESTION 55
The best choice of instrument for holiday testing of thick film concrete coatings is:

NEW QUESTION 56
Thermal Spray coatings provide:

NEW QUESTION 57
NACE Level 2 Inspectors have been authorized to perform:

NEW QUESTION 58
External coatings applied to buried pipelines are generally tested for:

NEW QUESTION 59
You are the NACY Coating Inspector on a tank lining project where desiccant dehumidification is being used. Since the first shift of abrasive blasting your readings have indicated relative humidity below 40%; however on the second shift of coating application your readings are indicting 80%.
Your FIRST preferred course of action is to:

NEW QUESTION 60
A single component water borne acrylic coating cures by:

NEW QUESTION 61
Individuals conducting Coating Surveys should:

NEW QUESTION 62
You have just your NACE CIP Level 2 certification when you are asked to supervise a team of uncertified field pipeline inspectors.
Your FIRST preferred course of action is to:

NEW QUESTION 63
The solvent sensitivity/solvent wipe test (ASTM D4752) is used to determine the cure of

NEW QUESTION 64
Non-Conformance Reports are designed to:

NEW QUESTION 65
Inspectors perform tests on linings that they may not perform on exterior coatings because

NEW QUESTION 66
Differences in technique for abrasive blasting concrete versus steel require the operator to:

NEW QUESTION 67
You are the new NACE Level 2 Inspector on a job which had been very problematic. The previous Inspector was fired duo to personality conflicts with the Contractor’s supervisor. Upon arriving onsite the Contractor’s supervisor advises you in no uncertain terms that you will be the next to go, unless you cooperate with him.
Your FIRST preferred course of action is to:

NEW QUESTION 68
When a coating is expected to be exposed to temperatures above 93C (200 F) the best choice would be:

NEW QUESTION 69
When performing an adhesion test in accordance with ASTM D 3359 where the Dry Film Thickness is approximately 10 mils, the Inspector should use:

NEW QUESTION 70
NACE International Standards are developed by:

NEW QUESTION 71
An Inspection and Test Plan is required when:

NEW QUESTION 72
When observing fabrication defects the NACE Inspector should:

NEW QUESTION 73
NACE Standards include:

NEW QUESTION 74
Generally for safety considerations, waterjetting hose connections use

NEW QUESTION 75
When observing design defects the NACE Inspector should: