[Q165-Q185] Full 300-415 Practice Test and 375 unique questions with explanations waiting just for you!

Q165. A policy is created to influence routing in the network using a group of prefixes. What policy application will achieve this goal when applied to a site list?

Q166. An engineer is tasked to improve throughput for connection-oriented traffic by decreasing round-trip latency Which configuration will achieve this goal?

Q167. Which component of the Cisco SO-WAN control plane architecture should be located in a public Internet address space and facilitates NAT-traversal?

Q168. What is an advantage of using auto mode versus static mode of power allocation when an access point is connected to a PoE switch port?

Q169.

Refer to the exhibit. An engineer is troubleshooting a control connection issue on a WAN Edge device that shows socket errors. The packet capture shows some ICMP packets dropped between the two devices. Which action resolves the issue?

Q170. Which OMP route is selected if it was learned from the same Cisco SD-WAN device at location S0123T4E56F78?

Q171. Refer to the exhibit.

A network administrator is configuring OMP in vManage to advertise all the paths for the same prefix from a site that has two WAN Edge devices Each WAN Edge device is connected to three ISPs and two private MPLS transports. What is the minimum value for ‘Number of Paths advertised per Prefix” that should be configured?

Q172. An administrator is configuring the severity level on the vManage NMS for events that indicate that an action must be taken immediately. Which severity level must be configured?

Q173. Which configuration step is taken on vManage after WAN Edge list is uploaded to support the on- boarding process before the device comes online?

Q174. Which configuration changes the packet loss priority from low to highly?
A)

B)

C)

D)

Q175. A customer wants to use AWS for Cisco SD-WAN IaaS services by deploying virtual SD-WAN routers in a transit AWS VPC. The transit VPC then connects via site-to-site IPsec tunnels to an AWS transit gateway.
Which transit VPC connects via site-to-site IPsec tunnels to an AWS transit gateway?

Q176. When a WAN Edge device joins the SD-WAN overlay, which Cisco SD-WAN components orchestrates the connection between the WAN Edge device and a vSmart controller?

Q177. Refer to the exhibit.

Which command-line configuration on a WAN Edge device achieves these results?

Q178. Drag and drop the attributes from the left that make each transport location unique onto the right. Not all options are used.

Q179. Refer to the exhibit. Which configuration must the engineer use to form underlay connectivity for the Cisco SD-WAN network?

Q180. What is the purpose of ”vpn 0” in the configuration template when onboarding a WAN edge node?

Q181. Where on vManage does an engineer find the details of control node failure?

Q182. Which destination UDP port is used by WAN Edge router to make a DTLS connection with vBond Orchestrator?

Q183. Which two prerequisites must be met before the Cloud onRamp for laaS is initiated on vManage to expand to the AWS cloud? (Choose two)

Q184. Which two products that perform lifecycle management for virtual instances are supported by WAN Edge cloud routers? (Choose two.)

Q185. What is the default value for the number of paths advertised per prefix in the OMP feature template?