Sep-2022 Pass NACE NACE-CIP2-001 Exam in First Attempt Easily [Q35-Q50]

NO.35 The coating applicator has ignored a enface preparation hold point and applied coating over the surface without a sign off from you as the inspector.
Your FIRST preferred course of action is to:

NO.36 Surface preparation of concrete is performed using:

NO.37 Galvanizing performs best in which of the following exposures:

NO.38 You are the NACE Inspector on a project where a stationary floating structure is being coated and you notice a self-smoothing anti-fouling coating has been specified.
This is not a good choice because:

NO.39 Which is used to calibrate a pH meter?

NO.40 When environmental enclosures are being used an inspector needs to be concerned about:

NO.41 Examples of non-ferrous metals include
Select All that Apply:

NO.42 As a NACE Level 2 Inspector, NACE clearly indicates that you ate qualified to independently produce final documentation for a shop project.

NO.43 Application of Thermal Spray Coatings requires:

NO.44 You are the NACE Coating Inspector on a tank lining project and are asked to perform a high voltage holiday test after the coating applicators have completed their final repairs. After meeting all the confined space entry permit you enter the tank and notice a very strong odor of solvent.
Your first course of action should to:

NO.45 Surface preparation methods for Non-ferrous metals are:

NO.46 Inspection and Test plans are developed by referencing:

NO.47 You are the NACE Level 2 Inspector on a project where overcoating of galvanized steel is being performed. The specification references SSPC SP 16 as the surface preparation method. At the pre-job meeting operations personnel make it clear that abrasive blasting will not permitted. The Owner’s representative asks you what other methods might be used.
Of the options shown below, what would be the preferred option in this situation?

NO.48 From a corrosion perspective, the main difference between Ferrous and Non-Ferrous Metals is:

NO.49 The standards defining surface cleanliness achieved by centrifugal blast cleaning are:

NO.50 When ASIN D 3363 is specified the Inspector must: