Pass Juniper JN0-682 PDF Dumps Recently Updated 132 Questions [Q40-Q59]

Q40. Exhibit.

You choose the EBGP design shown in the exhibit as your IP fabric design. You must ensure that both routes received by the spine nodes will be used for ECMP forwarding Which BGP parameter would need to be added to the EBGP configuration of the spine nodes to achieve this goal?

Q41. An EVPN-signaled VXLAN overlay has been deployed in the network shown in the exhibit. An EVPN LAG has been configured to connect host1 to the network, and device leaf1 has been elected as the designated forwarder.
In this scenario, which statement is true?

Q42. Referring to the exhibit, each node in the IP fabric is peering to its directly attached neighbor using EBGP.
Each node is peering using physical interface IP addresses. Leaf 2 and Leaf 3 are advertising the 10.1.1/24
network into EBGP. Spine 2 must be configured so that it can load-share traffic destined to the 10 1.1/24
network over both next-hop A and next-hop B.

Which two actions must be performed to accomplish this task? (Choose two.)

Q43. Referring to the exhibit, Host 1 and Host 3 have exchanged traffic.

In this scenario, which statement is true?

Q44. You are asked to design a deployment plan for a large number of QFX Series switches using ZTP. The ZTP
deployment plan must ensure all switches are configured with their designated configuration file.
Which DHCP option and subscription combination would be used to accomplish this task?

Q45. Which two statements describes an IP fabric? (Choose two.)

Q46. Exhibit.

You are attempting to configure filter-based forwarding in your data center. All traffic from Host1 that is going to Host2 should be inspected by the data center firewall. You have verified that the traffic is being forwarded from router leaf L1’s VRF-1 to its INSPECT-VRF. however, the traffic is not reaching service L2.
Referring to the exhibit, which two steps should you take to troubleshoot the problem? (choose two.)

Q47. Exhibit.

Referring to the exhibit, you have a data center with two PODs. Seamless EVPN-VXLAN stitching is used to facilitate communication between the PODs.
Which three statements are true in this scenario? (Choose three.)

Q48. You are troubleshooting a connectivity issue across a VXLAN overlay network. In the exhibit, you are using the ping overlay command from a local VTEP residing on a OFX 5120 to a remote VTEP residing on a separate QFX5120.
What is the problem in this situation?

Q49. Which two statements describe a VXLAN network identifier (VNI)? (Choose Two)

Q50. You are asked to scale the available bandwidth within your Clos data center network to support more east-west traffic. In this scenario, what are two ways to accomplish this task? (Choose two.)

Q51. Which EVPN router type prevents BUM traffic from looping back to a multihued host?

Q52. Which two statements describe EVPN based VXLAN implementations? (Choose two.)

Q53. Which two characteristics would you consider when selecting spine devices in an IP fabric?
(Choose two.)

Q54. You are designing a network for a small data center.
In this scenario, which underlay protocol allows for the simplest implementation?

Q55. Which event triggers the generation of a EVPN type-4 route?

Q56. What are two streaming data formats supported for network analytics? (Choose two.)

Q57. Your manager asks you to secure ARP and DHCP traffic across your local Ethernet links
In this scenario, which technology will accomplish this task?

Q58. A client with five data centers spread around the country uses MPLS L2VPNs to provides point- to- point data center interconnect between each data center in a full-mesh network. The client Is considering an MPLS EVEN implementation.
In this scenario, what are three advantages of using MPL5 EVEN interconnects? (Choose two.)

Q59. Which two statements are true about VRF routing instances? (Choose two.)