JN0-682 Practice Exam and Study Guides – Verified By DumpsTests Updated 130 Questions [Q40-Q58]

NEW QUESTION 40
Exhibit.

Referring to the exhibit, which statement is correct?

NEW QUESTION 41
Referring to the exhibit, each node in the IP fabric is peering to its directly attached neighbor using EBGP. Each node is peering using physical interface IP addresses. Leaf 2 and Leaf 3 are advertising the 10.1.1/24 network into EBGP. Spine 2 must be configured so that it can load- share traffic destined to the 10 1.1/24 network over both next-hop A and next-hop B.

Which two actions must be performed to accomplish this task? (Choose two.)

NEW QUESTION 42
Referring to the exhibit, which two statements are correct? (Choose two.)

NEW QUESTION 43
You are asked to enable visibility into your EVPN-VXLAN network traffic by monitoring traffic continuously. Which two statements are correct in this scenario? (Choose two.)

NEW QUESTION 44
You are troubleshooting an L3VPN that is part of an EVPN/MPLS DCI. You notice that the EVPN overlay BGP session toward 10.29.50.4 is unable to establish.

Why is the BGP session failing to establish?

NEW QUESTION 45
Which two statements are correct about VXLAN domains? (Choose two.)

NEW QUESTION 46
The configuration shown in the exhibit is intended to set up assisted replication but will not commit. Which action will create a valid configuration in this situation?

NEW QUESTION 47
You have deployed a VXLAN as shown in the exhibit Leaf1, leaf3, spine1, and spine2 have been configured as VTEPs. Host1 cannot communicate with host2.

Referring to the exhibit, how would you solve this problem?

NEW QUESTION 48
You are asked to deploy an Ethernet bridging design in a data center with the criteria shown below.
— Routing must occur on the spine devices.
– VTEPs must terminate on the leaf devices.
– Facilitate inter-VLAN communication.
— Layer 2 gateways must be present on spine and leaf devices.
Which architecture should you use in this scenario?

NEW QUESTION 49
You are building an IP fabric underlay network for your new data center. You must ensure that you have predictable load-balancing behavior throughout your network. According to Juniper Networks, what are two best practices that should be followed in this scenario? (Choose two.)

NEW QUESTION 50
Exhibit.



You are troubleshooting a connectivity issue across a VXLAN overlay network. In the exhibit, you are using the ping overlay command from a local VTEP residing on a OFX 5120 to a remote VTEP residing on a separate QFX5120.
What is the problem in this situation?

NEW QUESTION 51
Referring to the exhibit, you must advertise the Io0.12 interface as a type-5 route.
Which configuration parameter would be used to accomplish this task?

NEW QUESTION 52
You want to configure redundant Layer 3 gateways
In this scenario, which two juniper best practices would accomplish this task? (Choose two.)

NEW QUESTION 53
Referring to the exhibit, DC1 and DC2 have a DCI across a service provider WAN connection. Host1 in DC1 must have Layer 2 connectivity to host2 in DC2. A VXLAN tunnel must be created between VTEP1 and VTEP2.

In this scenario, which statement is true?

NEW QUESTION 54
You are implementing perimeter security for your data center. You need to inspect all traffic Layer 7 and
ensure the failure of a port or device will not result in an interruption to traffic flows.
In this scenario, which design would satisfy these requirements?

NEW QUESTION 55
You are asked to manage multicast traffic in the EVPN-VXLAN environment. You must ensure that multicast traffic is delivered only to the leaf device with interested receivers. In this scenario, which feature is required on leaf devices to accomplish this task?

NEW QUESTION 56
A client with five data centers spread around the country uses MPLS L2VPNs to provides point- to- point data center interconnect between each data center in a full-mesh network. The client Is considering an MPLS EVEN implementation.
In this scenario, what are three advantages of using MPL5 EVEN interconnects? (Choose two.)

NEW QUESTION 57
You are troubleshooting a traditional Clos Layer 3 IP fabric in your data center. You are reviewing the BGP configuration for one of your spine devices.
Referring to the exhibit, which statement is correct?

NEW QUESTION 58
Referring to the exhibit, which two statements are correct? (Choose two.)