Practice Test for NACE-CIP1-001 Certification Real 2022 Mock Exam [Q52-Q74]

QUESTION 52
Checking is

QUESTION 53
A single application coating film has a measured dry film thickness (DFT) between 4 and 5 mils (between 100 and 125 microns). The volume solids of the coating immediately before application were 67%, What wet film thickness (WFT) was applied?

QUESTION 54
ISO SA 2 is defined as:

QUESTION 55
Upon arrival of coating materials, the inspector should

QUESTION 56
An inspectors personal log book should contain:

QUESTION 57
Passivation can best be described as:

QUESTION 58
Non Conformance Reports are completed by the Inspector:

QUESTION 59
A NACE Coating Inspector is permitted to transport coating material when:

QUESTION 60
You ate the NACE Inspector on a job where NACE No. 2/SSPC – SP 10 has been specified. You are finding the Contractor is leaving mill scale on the on surface and as a result you have been rejecting the blast. The Contractor is very upset and has told you that the standard permits up to 5% of the mill scale to remain and still be in be in compliance with the standard.
Your FIRST preferred course of action is to:

QUESTION 61
The Inspector’s Log Book is generally:

QUESTION 62
Relative humidity is

QUESTION 63
Conventional spray is a good choice when:

QUESTION 64
An exposed area of the substrate or previous coat of a conductive coating material, often caused by poor application technique is called

QUESTION 65
Dew point is the temperature at which

QUESTION 66
Good records can provide maintenance departments with detailed information about ALL of the following EXCEPT

QUESTION 67
When using the ISO comparator in accordance with ISO 8503, if the surface profile does not directly compare to one of the four segments the inspector should:

QUESTION 68
ISO ST 3 is described as:

QUESTION 69
What is used to determine compressed air cleanliness?

QUESTION 70
Which one of the following documents is the best source for coating technical data:

QUESTION 71
Removal of surface contaminants is done by:

QUESTION 72
On a blast-cleaned surface, Ian ultraviolet light is generally used to detect

QUESTION 73
You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining.
Your FIRST preferred course of action is to:

QUESTION 74
When the joint NACE/SSPC abrasive blast cleaning standards are specified, the pictures in SSPC VIS 1 can be used as: